Top Ideas For Concrete Polishing
The polishing industry is one of the industries that have risen up rapidly. The companies that are growing and those that are coming up now are too many in this industry. Since the industry is attracting a large population, many companies will keep coming up as time goes on. The article has tips that can be applied by the companies to ensure there is good concrete polishing done. These tips are explained in this article.
The first tip of concrete polishing is to determine the surface hardness. This is done by testing its hardness using a concrete hardness tester. This helps in the selection of the abrasives. The surface then is scratched with the use of the tip number nine. Then the scratching is done in a descending order. This is done until the tip cannot do the scratching anymore. This is the level where the hardness is ok.
Then the concrete surface is then prepared. One can find coated floors for concrete polishing. Here, the coat is removed with the right equipment. The type of coating is what affects the equipment to be used in the removal of this coat. Some floors normally have cracks and holes. The repairing of this holes and cracks should be done first. The next thing that should be done is gritting with the metal bond tooling to the level and flatness that is desired.
Then the metal tool marks have to be removed. Transitional tooling can help here. The marks made by the tool can be removed very well with the use of transitional tooling. The process is considered successful when all the tool marks disappear.
Then vacuuming is done to densify and harden the floor. The pore and crack filer is used to densify and solidify the surface of the floor. It helps avoid water penetration that can result in stains that can result due to water penetration. However, care should be taken to avoid pooling of the floor by the densifiers. This is because pooling leads to permanent stains that can make polishing hard.
Then now the polishing is done after all the above things are complete. One is advised to start with the resign band. Then the space between the passes is vacuumed to remove the dust. Then the floor is burnished with a burnishing pad after the final grit level is achieved.
Then the last thing that should be done to the floor is protecting it. The floor get the protection by the sealing it. This will protect the surface from things like grease, oil, and any other chemicals. The pump can be used to apply the sealer to the floor. The floor can be left shining after burnishing is done. These are the best ideas that can allow successful concrete polishing.